|
 |
SKIVED JOINT
The CHIORINO transmission belts can be made endless using a
standard skive; directions here below.
|
K cement |
for polyamide |
PR - P - Z - T - DG - LT - LL |
|
|
for elastomer |
Z - T |
|
R cement
+
I hardener |
for elastomer
and leather |
DG - LT - LL |
|
AD cement
+
C hardener. |
for
MF elastomer |
DG MF |
|
KIT |
Recommended directions
(the adhesives are packed into their own KITS) |
|
NAILCOL |
Series PR - P - DG
Apply the K cement on the polyamide part of the splices. Let dry for 5 minutes, then match the belt ends, paying attention to align properly. Press according to the instructions shown. |
|
CARBOCOL |
Series Z
Apply the K cement on the polyamide part of the splices. Apply the H primer on the elastomer part of the two splices and the B cement on the elastomer part of a single splice.
Series T
Apply the K cement on the polyamide part of the splices. Apply the H primer on the four elastomer parts of the two splices and the B cement on the two elastomer parts of a single splice.
Let dry for 5 minutes, then match the belt ends, paying attention to align properly. Press according to the instructions shown. |
|
GUMMICOL |
Series DG - LT - LL
Apply the K cement on the polyamide part of the splices. Let dry for 5 minutes. Pour the I hardener with the R cement (pot-life 2-3 hours). Apply the above mix on the elastomer or leather part of the splices. Let dry for 5 minutes, then match the belt ends, paying attention to align properly. Press according to the instructions shown. |
|
MF CARBOCOL |
Series DG MF
Apply the K cement on the polyamide part of the splices and let dry for 5 minutes. Pour the AD cement with the C hardener (pot-life 2-3 hours) and apply the mix on the splices of the top surface. Pour the I hardener with the R cement (pot-life 2-3 hours) and apply the mix on the splices of the driving surface. Let dry for 5 minutes, then match the belt ends, paying attention to align properly. Press according to the instructions shown. |
To ensure best joint life it is advisable not to run or tension the belt for 24 hours.
FAST JOINTThe thermoplastic flat belts of the DU and AR series can be made endless up to 80 mm wide in a very short time with the fast joint system without use of cement, by means of the equipment shown here below.
|
|
|
